Electronics 1
A.Y. 2018/2019
Learning objectives
Students are introduced to circuit theory and to electronic devices and circuits.
Expected learning outcomes
Undefined
Lesson period: First semester
Assessment methods: Esame
Assessment result: voto verbalizzato in trentesimi
Single course
This course cannot be attended as a single course. Please check our list of single courses to find the ones available for enrolment.
Course syllabus and organization
Single session
Responsible
Lesson period
First semester
Course syllabus
- Electrical network theory: two-terminal components, independent generators, V-I characteristics, Ohm's law, Kirchhoff's laws, electrical power, four-terminal components.
- Linear networks: impulse response, convolution, frequency response, Laplace transform, transfer function, poles and zeroes, Bode plots.
- Introduction to the feedback theory: negative and positive feedback, properties of negative feedback circuits, gain-bandwidth product, stability and Bode stability criterion, phase margin, gain margin.
- Operational amplifier: virtual ground; circuits with op-amps in feedback configuration: voltage follower, inverting and non-inverting amplifiers, difference amplifier, summing amplifier.
- Semiconductor devices: junction diode, bipolar junction transistor, and MOS transistor. V-I charactristics. Biasing circuits. Equivalent circuits for small-signal analysis.
- Examples of analog circuits: rectifier, Zener voltage reference, emitter follower, common emitter and common base amplifiers, differential stage.
- CMOS technology and CMOS logic gates. Dynamic power consumption of CMOS logic.
- Linear networks: impulse response, convolution, frequency response, Laplace transform, transfer function, poles and zeroes, Bode plots.
- Introduction to the feedback theory: negative and positive feedback, properties of negative feedback circuits, gain-bandwidth product, stability and Bode stability criterion, phase margin, gain margin.
- Operational amplifier: virtual ground; circuits with op-amps in feedback configuration: voltage follower, inverting and non-inverting amplifiers, difference amplifier, summing amplifier.
- Semiconductor devices: junction diode, bipolar junction transistor, and MOS transistor. V-I charactristics. Biasing circuits. Equivalent circuits for small-signal analysis.
- Examples of analog circuits: rectifier, Zener voltage reference, emitter follower, common emitter and common base amplifiers, differential stage.
- CMOS technology and CMOS logic gates. Dynamic power consumption of CMOS logic.
FIS/01 - EXPERIMENTAL PHYSICS
ING-INF/01 - ELECTRONIC ENGINEERING
ING-INF/01 - ELECTRONIC ENGINEERING
Lessons: 48 hours
Professor:
Liberali Valentino
Professor(s)